With flatness, you can allow the table to be flat without constraining the tabletop thickness very tight. If you want to make sure that a tabletop is perfectly flat, if you did not have a flatness callout, you would have to constrain the height of the table very tightly to make sure that the entire surface is straight.

Commonly used on a fixture that must mate flush with another part without wobbling, but where orientation is not important. Usually, flatness is used to give a surface an even amount of wear or for sealing properly with a mating part.

When you want to constrain the amount of waviness or variation in a surface without tightening the dimensional tolerance of said surface. This would be measuring parallelism instead as you are fixing the bottom of the part as a datum.įlatness is the 3D version of surface straightness – Instead of the tolerance zone between two lines the tolerance zone exists between two planes. Flatness cannot be measured by simply placing the part on a granite slab and running a height gauge or microheight over it. This is a 3D measurement so points must be measured across the length and width of the part to ensure the entire surface is in tolerance. Modern CMM’s are best for measuring the part as they can create virtual planes that the true surface profile can be compared to. You are trying making sure that any point along the surface does not go above or below the tolerance zone. Two Sets of Parallel Planes where the entire referenced surface must lie.įlatness is can be measured using a height gauge run across the surface of the part if only the reference feature is held parallel. Flatness tolerance is always less than the dimensional tolerance associated with it. The flatness tolerance references two parallel planes (parallel to the surface that it is called out on) that define a zone where the entire reference surface must lie. It comes in useful if a feature is to be defined on a drawing that needs to be uniformly flat without tightening any other dimensions on the drawing. It is a common symbol that references how flat a surface is regardless of any other datums or features. Symbol: Relative to Datum: No MMC or LMC applicable: Yes – New in 2009 Drawing Callout: Description:

Flatness gd&t symbol